Kia Rio: Installation
| 1. |
Installation is the reverse of removal.
|
| 2. |
After installation, bleed the brake system.
(Refer to Brake system bleeding)
|
Removal
1.
Turn ignition switch OFF, and disconnect the negative (-) battery
cable.
2.
Remove the battery and ECM.
(Refer to the Engine Ele ...
Brake Line
...
See also:
Specification
Pressure
[kPa (kgf/cm², psi)]
Output Voltage (V)
20.0 (0.20, 2.9)
0.79
46.7 (0.47, 6.77)
1.84
101.3 (1.03, 14.7)
4 ...
Immobilizer Control Unit Installation
1.
Install the immobilizer unit.
2.
Connector the immobilizer unit.
3.
Install the crash pad lower panel.
...
Steering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
Copyright © www.kirmanual.com 2014-2024