1. |
Be sure there is no play in the fuse holders, and that the fuses
are held securely.
|
2. |
Are the fuse capacities for each circuit correct?
|
3. |
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the
same capacity. Always determine why the fuse blew first and completely
eliminate the problem before installing a new fuse.
|
Antenna Coil Installation
1.
Install the antenna coil.
2.
Connect the antenna coil connector.
3.
Install the crash pad lower panel.
...
Foot Actuator (With Auto Defogging System) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the foot connector.
3.
Verify that the foot actuator operates to ...
Rain Sensor Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are controlled
by the ...