Kia Rio: Auto Defogging Sensor (FATC only) Inspection
| 1. |
Press the MODE switch more then 4 times within 2 seconds while
pressing the OFF switch.
* For diagnostic procedure, refer to DTC guide.
|
Auto Defogging Sensor (FATC only) Description
The Auto Defogging Sensor is installed on the front windshild glass. The
Auto Defogging Sensor senses moisture on the windshild. The air conditioner
control module receives the signal from th ...
Auto Defogging Sensor (FATC only) Replacement
1.
Remove the auto defogging sensor cover (A).
2.
Disconnect the connector (B) and then remove the auto defogging
sensor (C).
...
See also:
Shift Lever Adjustment
Adjusting the control cable
1.
Set room side AT lever(shift lever) and automatic transaxle side
manual control lever to "N" position.
...
Door Switch Installation
1.
Install is reverse of removal.
...
Front Driveshaft Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...
Copyright © www.kirmanual.com 2014-2024