Kia Rio: Starter: Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Disconnect the starter cable (B) from the B terminal on the solenoid
then disconnect the connector from the S terminal (A).
|
| 4. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
Starter: Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
See also:
Starting the engine
WARNING - Proper footwear
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, ski boots, sandals, etc.) may interfere with your ability to use the
brake and a ...
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures
the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor ...
Multimedia Jack Installation
1.
Install the multimedia jack.
2.
Connect the multimedia jack connector.
...
Copyright © www.kirmanual.com 2014-2024