1. |
Basically, all measurements in this manual are taken with a tracking
gauge.
|
2. |
When a measuring tape is used, check to be sure there is no elongation,
twisting or bending.
|
3. |
For measuring dimensions, both projected dimension and actual-measurement
dimension are used in this manual.
|
Input Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
ESC Control Module Components
1. Front - left tube
2. Rear - right tube
3. Rear - left tube
4. Front - right tube
5. MC2
6. MC1
7. ESC control module (HECU)
8. Damper
9. Bracket
...
Hazard warning flasher lighting
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as po ...