Kia Rio: Transaxle Control Module (TCM) Terminal Function
Connector [EGGG-AA]
| Pin |
Description |
Pin |
Description |
| 22 |
Shift solenoid D (VFS-OD) |
73 |
Inhibitor switch signal "S4" |
| 23 |
Pressure cont solenoid (VFS-LINE) |
74 |
Inhibitor switch signal "S2" |
| 26 |
Shift solenoid F (SS-B) |
75 |
Inhibitor switch signal "S3" |
| 37 |
Sports mode up switch |
87 |
Solenoid power 1 |
| 38 |
Sports mode select switch |
88 |
Solenoid power 2 |
| 39 |
Oil temperature sensor (+) |
89 |
Shift solenoid E (SS-A) |
| 43 |
Shift solenoid A (VFS-UD) |
94 |
Inhibitor switch signal "S1" |
| 44 |
Shift solenoid C (VFS-35R) |
95 |
Output speed sensor power |
| 45 |
Torque converter control solenoid (T/CON_VFS) |
96 |
Input speed sensor power |
| 46 |
Shift solenoid B (VFS-26B) |
99 |
Input speed sensor signal |
| 58 |
Sports mode down switch |
100 |
Output speed sensor signal |
| 59 |
Oil temperature sensor (-) |
|
|
Connector [EGGG-AK]
| Pin |
Description |
Pin |
Description |
| 1 |
GND (Power) |
5 |
VB |
| 2 |
GND (Power) |
60 |
CAN High |
| 3 |
VB (Battery voltage) |
68 |
IG.1 ( Ignition key) |
| 4 |
Ground (Power) |
77 |
CAN Low |
See also:
Front Fog Lamps Installation
1.
Install the fog lamp.
2.
Reconnect the fog lamp connector.
3.
Connect the negative (-) battery terminal.
...
Troubleshooting
...
Back-up Lamp Switch Replacement
1.
Disconnect the back up lamp switch connector (A).
2.
Remove the back up lamp switch (A).
3.
...
Copyright © www.kirmanual.com 2014-2024