Kia Rio: 35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description
Underdrive brake control solenoid valve(UD/B_VFS) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the underdrive brake.
...
See also:
Schematic Diagrams
Circuit Diagram - ESC (1)
Circuit Diagram - ESC (2)
Circuit Diagram - ESC (3)
Circuit Diagram - ESC (4)
ESC connector input/output
Connector Terminal
Specifi ...
Radiator: Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
(-) terminal (without battery sensor):
7.8 ~ 9.8N.m (0.8 ~ 1.0 ...
Rear Wiper Motor Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals ...
Copyright © www.kirmanual.com 2014-2024