1. |
Remove the antenna jack from the audio unit and antenna.
|
2. |
Check for continuity between the center poles of antenna cable.
|
3. |
Check for continuity between the outer poles of antenna cable.
There should be continuity.
|
4. |
If there is no continuity, replace the antenna cable.
|
5. |
Check for continuity between the center pole (A) and outer pole
(B) of antenna cable. There should be no continuity.
|
6. |
If there is continuity, replace the antenna cable.
|
Installation
Installation is the reverse of removal.
Canister installation bolt/nut:
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
Side Impact Sensor (SIS) Components
...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...