Kia Rio: Audio Unit Removal
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or trim remover, remove the center fascia
panel (A).
|
| 3. |
Disconnect the start/stop button connector (A) and hazard switch
connector (B).
|
| 4. |
After loosening the mounting screws, then remove the audio assembly
(A).
|
| 5. |
Disconnect the audio connector and cable (A).
|
Audio Unit Description
Introduction to CD
•
If the temperature inside the car is too high, open the car windows
for ventilation before using your car audio.
•
It is ...
Audio Unit Installation
1.
Connect the audio unit connectors and cable.
2.
Install the audio unit.
3.
Install the crash pad center fas ...
See also:
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine comp ...
Measuring Body Dimensions
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust ...
Copyright © www.kirmanual.com 2014-2024