Kia Rio: Auto Defogging Sensor (FATC only) Inspection
| 1. |
Press the MODE switch more then 4 times within 2 seconds while
pressing the OFF switch.
* For diagnostic procedure, refer to DTC guide.
|
Auto Defogging Sensor (FATC only) Description
The Auto Defogging Sensor is installed on the front windshild glass. The
Auto Defogging Sensor senses moisture on the windshild. The air conditioner
control module receives the signal from th ...
Auto Defogging Sensor (FATC only) Replacement
1.
Remove the auto defogging sensor cover (A).
2.
Disconnect the connector (B) and then remove the auto defogging
sensor (C).
...
See also:
Input Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...
Manual Transaxle Installation
When replacing a clutch housing or transaxle assembly, the wiring
bracket should be installed in accordance with the clu ...
Copyright © www.kirmanual.com 2014-2024