1. |
Be sure to disconnect the battery cable from the negative (-)
terminal of the battery.
|
2. |
Never pull on the wires when disconnecting connectors.
|
3. |
Locking connectors will click when the connector is secure.
|
4. |
Handle sensors and relays carefully. Be careful not to drop them
against other parts.
|
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Immobilizer Control Unit Installation
1.
Install the immobilizer unit.
2.
Connector the immobilizer unit.
3.
Install the crash pad lower panel.
...
Specifications
Item
Specification
Rated voltage
DC 3V
Service voltage range
DC 2.7V ~ 3.5V
Temperature range
-4°F ~ 140°F (-20°C ~ +60°C)
...