Kia Rio: Front Hub / Knuckle Reassembly
|
1. |
Install the hub bearing to the knuckle assembly.
|
(1) |
Lay the knuckle assembly (A) on press.
|
|
(2) |
Lay a new hub bearing upon the knuckle assembly (A).
|
|
(3) |
Lay a suitable adapter (B) upon the hub bearing.
|
|
(4) |
Install the hub bearing to the knuckle assembly by using
press.
|
- |
Do not press against the inner race of
the hub bearing because that can cause damage
to the bearing assembly.
|
|
- |
Always use a new wheel bearing assembly.
|
|
|
|
|
2. |
Install the dust cover (A).
|
|
3. |
Install the hub assembly to the knuckle assembly.
|
(1) |
Lay the hub assembly (A) upon a suitable adapter (B).
|
|
(2) |
Lay the knuckle assembly (C) upon the hub assembly (A).
|
|
(3) |
Lay a suitable adapter (D) upon the hub bearing.
|
|
(4) |
Install the hub assembly (A) to the knuckle assembly (C)
by using press.
Do not press against the inner race of the hub
bearing because that can cause damage to the bearing
assembly.
|
|
|
|
4. |
Install the snap ring (A).
|
1.
Remove the snap ring (A).
2.
Remove the hub assembly from the knuckle assembly.
(1)
Install the ...
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...
See also:
Rear Coil Spring Components
1. Spring upper pad
2. Spring
3. Spring lower pad
...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
Accelerator Pedal Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
Front Hub / Knuckle Disassembly
Front Hub / Knuckle Inspection