Kia Rio: Heated Steering wheel Inpection
1. |
Measure a resistance of NTC and Heated pad.
A. |
NTC resistance(Black / Yellow, Black) - 10.0 kΩ ± 10%
(25°C(77°F))
|
B. |
Heated pad resistance (Yellow, Black) - 1.6 ~ 2.0 Ω ±
10%
|
|
2. |
Measure a temperature.
A. |
The temperature of wheel surface grip must rise from -20°C(-68°F)
to 20°C(68°F) within 6 minute
|
B. |
The temperature of wheel surface grip must keep 38°C ±
4°C( 100.4°F ± 39.2°F) after 25 minute
|
C. |
At that time switch on, all measure point (1~8)
|
|
Terminal Function
Housing
Pin
Function
Wire color
Pad
A
GND
Back
B
HEATER
Yellow
C
...
See also:
Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...
Limp Home Function
1.
Limp Home By Tester
If the ECM detects the fault of the Immobilizer or transponder,
the ECM will allow limp home function of the immobilizer. Limp home
is o ...
Front Driveshaft Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...