Kia Rio: Inhibitor Switch Circuit Diagram

Inhibitor Switch Specifications

▷ Type: Combination of output signals from 4 terminals Power supply (V) 12 Output type Combination of output signals Signal Code Table ...

Inhibitor Switch Removal

1. Place the shift lever into the "N" position. 2. Remove the air cleaner assembly. (1) Remove t ...

See also:

Ignition Coil: Installation
1. Install in the reverse order of removal. Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft) ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS termi ...

TPMS Sensor Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...