1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Measure the output voltage of the FTPS.
|
Blower Resistor (MANUAL) Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
Installation
1.
Installation is the reverse of removal.
Use a new washer (A) whenever ...
Wipers & Washers
A : Wiper speed control (front)
HI – High wiper speed
LO – Low wiper speed
INT – Intermittent wipe
AUTO– Automatic control wipe
OFF – Off
MIST – Single wipe
B : Intermittent control ...