Kia Rio: Normal maintenance schedule - Engine compartment - Maintenance - Kia Rio UB 2012-2025 Owners ManualKia Rio: Normal maintenance schedule

The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty.

Where both mileage and time are shown, the frequency of service is determined by whichever occurs first.

7,500 miles or 6 months

*1 lnspect "Water Pump" when replacing  the drive belt or timing belt.

*A If TOP TIER Detergent Gasoline is not available, one bottle of additive is recommended.

Additives are available from your authorized Kia dealer along with information on how to use them. Do not mix other additives.

❈ Inspect : Inspect and if necessary, adjust, correct, clean or replace.

15,000 miles or 12 months

30,000 miles or 24 months

45,000 miles or 36 months

60,000 miles or 48 months

75,000 miles or 60 months

90,000 miles or 72 months

105,000 miles or 84 months

120,000 miles or 96 months

135,000 miles or 108 months

150,000 miles or 120 months

Owner maintenance
The following lists are vehicle checks and inspections that should be performed by the owner or an authorized Kia dealer at the frequencies indicated to help ensure safe, dependable operation of y ...

Maintenance under severe usage conditions
The following items must be serviced more frequently on cars normally used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals. R : Replace I : I ...

See also:

Explanation of scheduled maintenance items
Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the vehicle is being driven in severe conditions, more frequent oil an ...

Front Stabilizer Bar Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. 3. Check th ...

Blower Resistor (MANUAL) Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Copyright © www.kirmanual.com 2014-2025