Kia Rio: Output Speed Sensor Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2025 Service ManualKia Rio: Output Speed Sensor Installation

1.
Installation is the reverse of removal.

     
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
The gasket of the valve body gasket (A) use new one.


Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
Output Speed Sensor Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Description
Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque converter. ...

See also:

Yaw-rate and G Sensor Description
When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate sensor. If yaw ...

Starter: Removal and Installation
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to EM group) 3. ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

Copyright © www.kirmanual.com 2014-2025