1. |
Remove the front door quadrant delta cover.
(Refer to the BD group - "Front door")
|
2. |
Disconnect the power door mirror connector from the harness.
|
3. |
Apply battery voltage to each terminal as shown in the table and
verify that the mirror operates properly.
Side Repeater Lamp
Mirror Heater
With Folding Mirror
|
Front Hub / Knuckle Disassembly
1.
Remove the snap ring (A).
2.
Remove the hub assembly from the knuckle assembly.
(1)
Install the ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
Specification
Engine
T/M
Joint type
Max. permissible angle
Outer
Inner
Outer
Inner
Gasoline 1.6
MT, AT
BJ#82
TJ#82
...