1. |
Disconnect the battery negative (-) cable.
|
2. |
Disconnect the battery sensor connector.
|
3. |
Remove the battery sensor cable after removing the bolts (A).
|
Auto Light Switch Inspection
Operate the auto light switch, then check for continuity between terminals
of multi-function switch connector.
...
Instrument panel vents
The outlet vents can be opened or closed separately using the thumbwheel.
Also, you can adjust the direction of air delivered from these vents using the
vent control lever as shown.
Temperature ...
Rain Sensor Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are controlled
by the ...