Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the purge control solenoid valve connector (A).
|
| 3. |
Disconnect the vapor hoses (B) from the purge control solenoid
valve.
|
| 4. |
Remove the valve after removing the bolt (C).
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV termi ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Inspection
Steering Wheel Play Inspection
1.
Turn the steering wheel so that the front wheels can face straight
ahead.
2.
Measure the distance the ...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Components
1. Receiver
2. TPMS Sensor (S1)
3. TPMS Sensor (S4)
4. TPMS Sensor (S2)
5. TPMS Sensor (S3)
6. Tread Lamp
...
Copyright © www.kirmanual.com 2014-2024