Kia Rio: Removal
| 1. |
Remove the transaxle assembly.
(Refer to "Manual transaxle system" in MT group)
|
| 2. |
Remove the clutch cover bolts. Be careful not to be bent ortwist
bolts. Loosen bolts in diagonal directions.
|
Components
1. Clutch release fork
2. Clutch cover assembly
3. Clutch disk assembly
4. Clutch release bearing
...
Inspection
1.
Inspect diaphragm spring wear which is in contact with a concentric
slave cylinder bearing.
2.
Check the clutch cover and disc surface f ...
See also:
Ignition Switch Assembly Inspection
1.
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
2.
Check for continui ...
Engine oil
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes ...
Overhead Console Lamp Installation
1.
Install the overhead console lamp after connecting the sunroof
switch connector and lamp connector.
2.
Install the lens after tightening ...
Copyright © www.kirmanual.com 2014-2024