Kia Rio: Removal
| 1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
| 2. |
Remove the seat belt after pushing the lock pin (A).
|
| 3. |
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
|
| 4. |
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
|
| 5. |
Remove the upper anchor bolt.
|
| 6. |
Disconnect the seat belt pretensioner connector (A).
|
| 7. |
Loosen the seat belt pretensioner mounting bolts (B, C) and remove
the seat belt pretensioner.
|
Components
...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
See also:
Inspection
Horn Inspection
Test the horn by connecting battery voltage to the 2 terminal and ground
the 1 terminal.
1 : 12V Ground(-)
2 : 12V (+)
...
Room Lamp Inspection
Room Lamp
Remove the room lamp assembly then check for continuity between terminal.
If the continuity is not as specified, replace the room lamp assemlby.
...
Front Hub / Knuckle Components
1. Snap ring
2. Bearing
3. Axle assembly
4. Brake disc dust cover
5. Wheel hub assembly
6. Wheel brake disc
7. Brake disc fixing screw
...
Copyright © www.kirmanual.com 2014-2024