Kia Rio: Instrument Cluster Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or romover, remove the cluster fascia panel
(A).
|
| 3. |
Disconnect the start/stop button connector (A) and hazard switch
connector (B).
|
| 4. |
Using a screwdriver or remover, remove the cluster fascia panel
(A).
|
| 5. |
Remove the cluster fascia (A) from the crash pad after removing
2 screws.
|
| 6. |
Disconnect the cluster fascia connecters (A) and then remove the
cluster.
|
Instrument Cluster Inspection
Speedometer
1.
Adjust the pressure of the tires to the specified level.
2.
Drive the vehicle onto a speedometer tester. Use wheel chocks
...
Instrument Cluster Installation
1.
Connect the cluster connector.
2.
Install the cluster assembly.
3.
Install the center fascia panel.
...
See also:
Photo Sensor (FATC only) Description
The photo sensor is located at the center of defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode.
The solar radiation received by its light receiving port ...
[CVVT System Mode]
(1) Low Speed / Low Load
(2) Part Load
(3) Low Speed / High Load
(4) High Speed / High Load
...
Brake Booster Vacuum Pressure Sensor: Description
In order to ensure adequate brake power assistance in every situation,
the brake booster is equipped with a partial vacuum sensor. The brake booster
vacuum pressure sensor is located beside t ...
Categories
- Kia Rio Manuals Home
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright © www.kirmanual.com 2014-2025