Kia Rio: Power Door Lock Switch Inspection
Driver Door Lock Switch Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
| 3. |
Disconnect the connector from the power window switch module.
|
| 4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Power Door Lock Actuators Inspection
Front Door Lock Actuator and Switch
1.
Remove the front door trim.
(Refer to the Body group - Front door)
2.
Remove the front door l ...
Power Door Lock Switch Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
...
See also:
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
AGM Battery: Inspection
Battery Diagnostic Flow
Vehicle parasitic current inspection
1.
Turn all the electric devices OFF, and then turn the ignition
switch OFF.
...
Engine overheat
If your temperature gauge indicates overheating, you will experience a loss of
power, or hear loud pinging or knocking, the engine is probably too hot. If this
happens, you should:
1.Pull off the ...
Categories
- Kia Rio Manuals Home
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright © www.kirmanual.com 2014-2025