Kia Rio: Power Door Mirror Actuator Inspection
| 1. |
Remove the front door quadrant delta cover.
(Refer to the BD group - "Front door")
|
| 2. |
Disconnect the power door mirror connector from the harness.
|
| 3. |
Apply battery voltage to each terminal as shown in the table and
verify that the mirror operates properly.
Side Repeater Lamp
Mirror Heater
With Folding Mirror
|
Power Out Side Mirror Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
...
Power Windows
...
See also:
Hood switch Removal
1.
After loosening the mounting bolts and connector, then remove
the hood switch (A).
...
Special driving conditions
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud,
sand, or similar hazards, follow these suggestions:
Drive cautiously and allow extr ...
Yaw-rate and G Sensor Description
When the vehicle is turning with respect to a vertical axis the yaw rate
sensor detects the yaw rate electroniclly by the vibration change of plate fork
inside the yaw rate sensor.
If yaw ...
Copyright © www.kirmanual.com 2014-2024