Kia Rio: Rain Sensor Installation - Windshield Wiper/Washer - Body Electrical System - Kia Rio UB 2012-2024 Service ManualKia Rio: Rain Sensor Installation


     
In case of the windshield with reflection layer which reflects the infrared rays in sensing field, remove the reflection layer from the rain sensor mounting position prior to installation.
Avoid contamination of the sensor during installation.
1.
Install the rain sensor bracket to the windshield glass using the tape.



     
It is very important that the coupling pad pushes against the windshield completely to prevent bubbles from forming at the contact surface.
2.
Connect the rain sensor connector, and then install the sensor cover.
Rain Sensor Removal
   The rain sensor may not operate properly if contaminated. Protect the rain sensor surface by not removing the cover unti ...

Rear Wiper/Washer
...

See also:

Filler-Neck Assembly Removal
1. Open the fuel filler door, and then remove the filler-neck assembly mounting screws (A). 2. Disconnect the fuel filler hose (A) ...

Ending voice recognition
While Voice Recognition is operating Press and hold the key on the steering remote controller (over 0.8 seconds) While using voice command, pressing any steering wheel control or a differen ...

Interior light
Do not use the interior lights for extended periods when the engine is not running. It may cause battery discharge. WARNING - Interior light Do not use the interior lights when driving in the dark. ...

Copyright © www.kirmanual.com 2014-2024