1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the roof trim. (Refer to the BD group - " Roof trim")
|
3. |
Disconnect the connector and remove the sunroof motor (A) with
loosening 2 screws.
|
4. |
Ground the terminals as below table, and check that the sunroof
unit operates as below table.
|
5. |
Make these input tests at the connector.
If any test indicates a problem, find and correct the cause, then
recheck the system.
If all the input tests prove OK, the sunroof motor must be faulty;
replace it.
|
1. |
Turn the ignition key to the ON position and then close the sunroof
completely.
|
2. |
Release the sunroof control lever.
|
3. |
Press and hold the CLOSE button for more than 10 seconds until
the sunroof closed and it has moved slightly.
|
4. |
Release the sunroof control lever.
|
5. |
Press and hold the CLOSE button once again within 5 seconds until
the sunroof do as follows;
|
6. |
Reset procedure of panorama system is finished.
|
1. |
The sunroof ECU detects the Run- time of motor
|
2. |
Motor can be operated continuously for the 1st run-time(120 ±
10sec.).
|
3. |
The continuous operation of motor stops after the 1st Run-time(120
± 10sec.).
|
4. |
Then Motor is not operated for the 1st Cool-time(18 ± 2sec.).
|
5. |
Motor is operated for the 2nd Run-time(10 ± 2sec.) at the continued
motor operation after 1st Cool-time(18 ± 2sec.)
|
6. |
The continuous operation of motor stops operating after the 2nd
Run-time(10 ± 2sec.)
|
7. |
Motor is not operated for the 2nd Cool-time(18 ± 2sec.).
|
8. |
Motor repeats the 2nd run-time and 2nd cool-time at the continued
motor operation.
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,
T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.
|
Overhead Console Lamp Circuit Diagram
...
Photo Sensor (FATC only) Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward photo sensor using a lamp, a ...
Lubricants
Item
Specified lubricant
Quantity
Transaxle fluid
ATF SP-Ⅳ or equivalent
7.3L (1.93 U.S gal., 7.71 U.S.qt., 6.42 Imp.q ...