Kia Rio: Hazard Lamp Switch Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or trim remover, remove the hazard lamp switch
(A).
|
| 3. |
Disconnect the hazard lamp switch connector.
|
License Lamp Installation
1.
Install the bulb.
2.
Connect the lens and license lamp.
...
Hazard Lamp Switch Installation
1.
Connect the connectors.
2.
Install the hazard lamp switch.
3.
Connect the negative (-) battery terminal.
...
See also:
Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harness connector as TCM side c ...
Front Door Replacement
Front Door Trim Replacement
•
Take care not to scratch the door trim and other parts.
...
Special driving conditions
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud,
sand, or similar hazards, follow these suggestions:
Drive cautiously and allow extr ...
Copyright © www.kirmanual.com 2014-2024