Kia Rio: Rear combination lamp Installation
| Rear combination lamp (Inside) |
[4 Door]
| 1. |
Install the rear combination lamp assembly.
|
| 2. |
Connect the rear combination connector.
|
| 3. |
Install the trunk trim.
|
| 4. |
Connect the negative (-) battery terminal.
|
[5 Door]
| 1. |
Install the rear combination lamp assembly.
|
| 2. |
Connect the rear combination connector.
|
| 3. |
Connect the negative (-) battery terminal.
|
| Rear combination lamp (Outside) |
| 1. |
Install the rear combination lamp assembly.
|
| 2. |
Connect the rear combination lamp connector.
|
| 3. |
Connect the negative (-) battery terminal.
|
Rear combination lamp Removal
Rear combination lamp (Inside)
[4 Door]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim.
(Ref ...
Troubleshooting
1.
The lamp switch inputs can be checked using the GDS.
2.
To check the input value of lamp switch, select option "Body Control
Module ...
See also:
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Direct control VFS[35R/C]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42)
Current value(mA ...
Input Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(1.2 ~ 1.8)
0.0472 ~ 0.0709
Output volta ...
Copyright © www.kirmanual.com 2014-2024