Kia Rio: Description
Back view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through
the ECM (Reverse Display Room Mirror) mirror or AVN head unit while backing-up.
This system is a supplementary function only. It is the responsibility
of the driver or always check the inside/ outside rearview mirror and
the area behind the vehicle before and while backing up because there
is a dead zone that can't see through the camera.
|
Circuit Diagram
...
Removal
1.
Remove the trunk trim in the trunk after removing the screws and
clips.
(Refer to the BD group - "Tailgate")
2.
Remove ...
See also:
26 Brake Control Solenoid Valve(26/B_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Rear Wheel Speed Sensor Inspection
1.
Measure the output voltage between the terminal of the wheel speed
sensor and the body ground.
...
Removal
1.
Remove the cyliner head cover.
(Refer to Timing System)
2.
Remove the timing chain cover.
(Refer to Timing System)
...
Copyright © www.kirmanual.com 2014-2024