Kia Rio: Measuring Actual Dimensions
| 1. |
These dimensions indicate the actual linear distance between measurement
points, and are used as the reference dimensions when a tracking gauge
is used for measurement.
|
| 2. |
First adjust both probes to the same length (A=A') before measurement.
|
Dimensions Projected
1.
These are the dimensions measured when the measurement points
are projected from the vehicle's surface, and are the reference dimensions
used for used for body ...
Measurement Point
Measurements should be taken at the center of the hole.
...
See also:
Start/Stop Button Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the Audio.
(Refer to the BE group - "Audio")
3. ...
Hazard warning flasher lighting
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as po ...
Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harness connector as TCM side c ...
Categories
- Kia Rio Manuals Home
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright © www.kirmanual.com 2014-2025