Kia Rio Manuals

Kia Rio: Oil Pan: Removal - Lubrication System - Engine Mechanical System - Kia Rio UB 2012-2025 Service ManualKia Rio: Oil Pan: Removal

1.
Remove the under covers (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)


2.
Drain engine oil.
3.
Using the SST(09215-3C000) and remove the oil pan.



     
•
Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of arrow.
•
After tapping the SST with a plastic hammer along the direction of more than 2/3 edge of the oil pan, remove it from the arrow around
more than 2/3 edge of the oil pan, remove it from the ladder frame.
•
Do not turn over the SST abruptly without tapping. It be result in damage of the SST.
Engine Oil Flow Diagram
...

Oil Pan: Installation
1. Install the oil pan. (1) Using a razor blade and gasket scraper, remove all the old packing material from the gasket surfaces. ...

See also:

Removal
   When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. ...

Compressor Description
The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of engine. The compressor changes the low pressure and low temperature r ...

Removal
1. Disconnect the battery terminal (A). 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - & ...

Categories


Copyright © www.kirmanual.com 2014-2025