Kia Rio: Removal
| 1. |
Disconnect the battery terminal (A).
|
| 2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Remove the battery mounting bracket and the insulation pad (A),
and then remove the battery(B).
|
| 4. |
Disconnect the ECM connector (A), and then remove ECM (B) after
removing the bolts/nut.
|
| 5. |
Remove the battery tray (C) after removing the bolts.
|
Adjustment
Battery charging
In general, vehicle battery charging system has three forms.
1.
Constant current charge: The battery voltage gradually rises by
chargi ...
Installation
1.
Install in the reverse order of removal.
Battery (-)terminal installation
[with battery sensor] :
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf. ...
See also:
Muffler: Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
Without battery sensor :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ ...
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based
on signal of A/C control unit. Pressing mode select switch ...
Passenger Airbag (PAB) ModuleInstallation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for
at least thirty seconds bef ...
Copyright © www.kirmanual.com 2014-2025