Kia Rio: Description
The Electronic Throttle Control (ETC) System consists of a throttle body
with an integrated control motor and throttle position sensor (TPS). Instead
of the traditional throttle cable, an Accelerator Position Sensor (APS) is used
to receive driver input. The ECM uses the APS signal to calculate the target
throttle angle; the position of the throttle is then adjusted via ECM control
of the ETC motor. The TPS signal is used to provide feedback regarding throttle
position to the ECM. Using ETC, precise control over throttle position is possible;
the need for external cruise control modules/cables is eliminated.
| 1. Dry bearing 2. DC motor 3. Non-contact hall sensor 4. Gear |
5. Magnet 6. Hall IC 7. Yoke 8. Stator |
See also:
Circuit Diagram
Hamess Connector
Pin No.
Discription
Remark
1
-
2
-
3
-
4
...
Wheel Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV termi ...
Copyright © www.kirmanual.com 2014-2024