1. |
Remove the combustion seal (A) with a wire cutter.
|
2. |
Before the assembly of the sealing ring the groove must be cleaned
using a clean cloth.
Any coking of the injector sealing surface must be carefully removed
with a brass-wire brush.
|
3. |
Place the combustion seal on the coneand pull downward on the
seal as indicatedin the photo.
Your fingers will work better forinstalling the Combustion Seal
overthe cone.
|
4. |
Pull the seal downward until it is near thebottom of the cone
as shown in the photo.
|
5. |
Place the cone (with seal) on the end ofthe injector.
Place the sizing tool (SST No.: 09353-2B000) overthe cone. Make
sure the tool flange istoward the seal as shown.
Press down on the tool to work the sealover the injector and into
the groove.
|
6. |
Because the seal will stretch as it goesover the end of the injector,
it will be a bitoversized after installation.
By letting the injector and seal set for a fewminutes, the seal
may reduce in size.
Inspect the seal for damage before continuing.
|
7. |
Place the resizing tool (flange up) over theseal. Twist the tool
slightly while pushingdown over the seal. This should reduce thesize
of the seal.
|
8. |
Place injector into the head as shown.
|
9. |
Twist slightly while pressing the injectorinto position in the
head.
This should complete the resizing of theseal.
Remove the injector and inspect the sealbefore completing the
injector installation process.
|
10. |
If the injector comes with a protective steelwasher held in place
by a spring clip; bothwill have to be removed before installation.
|
11. |
Install the Washer Seal onto injector withthe rubber side (stepped)
toward theinjector.
|
12. |
The stepped rubber side of the seal goes towards the injector.
|
13. |
The flat washer side of the seal goes towards the head.
|
Special Service Tools
Tool (Number and name)
Illustration
Use
Crankshaft front oil seal installer
(09455-21200)
Installation of the front oil seal
Va ...
Heater Unit Components
1. Shower Duct (Left)
2. Heater Pipe Cover
3. Mode Control Actuator
4. Mode Control Actuator Bracket
5. Defog mode lever (FATC)
6. Mode Control Main Lever (MANUAL)
7. Vent ...
Rear Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always p ...