Kia Rio: Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the CVVT oil control valve connector (A).

3.	Remove the installation bolt (B), and then remove the valve from the engine. [Bank 1 / Intake] [Bank 1 / Exhaust]

Inspection

1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV termina ...

Installation

• Install the component with the specified torques. • ...

See also:

Front Washer Motor Removal
- When servicing the washer pump, be careful not to damage the washer pump seal. ...

Special Tools
Tool (Number and name) Illustration Use 09800-21000 Ornament remover Trim removal 09853-31000 Headliner clip remover ...

Ambient Temperature Sensor Description
The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, ...

Categories

Copyright © www.kirmanual.com 2014-2025