1. |
Turn ignition switch OFF.
|
2. |
Disconnect the solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
|
AVN Head Unit Components
AVN (A/V & Navigation) Head Unit Connector
NO
Connector A
Connector B
1
Rear left spearker +
-
2
Front left ...
Dynamic Damper Replacement
1.
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
2.
Remove the TJ joint assembly. (Refer to DS group - “TJ joint”)
...
TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...