Kia Rio: Steering Gear box Components
| 1. Tie-rod end 2. Lock nut 3. Bellows clip 4. Bellows 5. Tie rod |
6. Rack bar 7. Dust packing 8. Dust cap 9. Oil seal 10. Pinion plug |
11. Pinion assembly 12. Yoke plug 13. Yoke spring 14. Support yoke assembly 15. Rack housing |
Steering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
Steering Gear box Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
See also:
Antenna Coil Installation
1.
Install the antenna coil.
2.
Connect the antenna coil connector.
3.
Install the crash pad lower panel.
...
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake
door by signal from control unit. Pressing the intake selection switch will
shift between recirculation and fresh ai ...
Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...
Copyright © www.kirmanual.com 2014-2024