Kia Rio: Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH and RH).
Side Pressure Sensor is also called P-SIS because it detects pressure
due to collision at its mounting location.
Side Impact Sensor is also called A-SIS because it detects acceleration.
SRSCM decides deployment of the airbag and the time of deployment through
the collision signal of the SIS when the collision occurred.
Front Impact Sensor (FIS) Installation
•
Do not turn the ignition switch ON and do not contact
the battery cable while replacin ...
See also:
Alternator: Specification
Items
Specification
ISG Alternator
Rated voltage
13.5V, 110A
Speed in use
1,000 ~ 18,000rpm
Voltage regulator
...
Replacement
Rear Brake Pads
1.
Loosen the guide rod bolt (B) and then remove the rear caliper
body (A).
Tightening torque:
21.6 ~ 31 ...
Ambient Temperature Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the engine room RH side under cover.
(Refer to EM group - “Engine and Transax ...
Copyright © www.kirmanual.com 2014-2025