Kia Rio: Troubleshooting
| Symptom |
Suspect Area |
Remedy (Refer to page) |
| Water leaks from sunroof |
Dirt accumulated in drain tube |
Clear dirt inside of drain |
| Clogged drain tube |
Blow air into drain to remove dirt |
|
| Broken or dislocated drain tube, defective or cracked clip |
Check tube installation and flange contact |
|
| Deteriorated roof lid weatherstrip |
Replace |
|
| Excessive roof lid-to-body clearance and improperly fitted weatherstrip |
Adjust |
|
| Wind noise around sunroof |
Loosen or deformed deflector, gaps in body work |
Retighten adjust or replace |
| Sunroof lid makes a noise when move |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
| Loosen guide rails and lid |
Retighten |
|
| Motor runs but sunroof does not move or moves only partially |
Foreign particles lodged in guide rail |
Adjust or replace |
| Incorrect engagement of motor pinion with drive cable |
||
| Decrease in motor`s clutch slipping force |
||
| Increased sunroof sliding resistance or interference of sunroof
with drive cables, weatherstrip, etc. due tomal adjustment of sunroof |
||
| Noise in motor (clutch slipping noise from motor when sunroof
is fully opened or closed is not an unusual noise |
Incorrect engagement of motor pinion with drive cable |
Check pinion installation and Re-tighten motor |
| Worn out or damaged motor pinion bearing |
Replace motor assembly |
|
| Worn out or deformed drive cable |
Replace |
|
| Door glass fails to operate up and down |
Incorrect window glass installation |
Adjust position |
| Damaged or faulty regulator arm or regulator |
Correct or replace |
|
| Door does not open or close completely |
Incorrect door installation |
Adjust position |
| Defective door check assembly |
Correct or replace |
|
| Door hinge requires grease |
Apply grease |
|
| Hood does not open or close completely |
Striker and latch not properly aligned |
Adjust |
| Incorrectly installed hood |
Adjust |
|
| Incorrect hood bumper height |
Adjust |
|
| Water leak through windshield end rear window |
Defective seal |
Fill with sealant |
| Defective flange |
Correct |
Special Tools
Tool (Number and name)
Illustration
Use
09800-21000
Ornament remover
Trim removal
09853-31000
Headliner clip remover
...
Body Dimensions
...
See also:
Smart key unit Circuit diagram
No.
Connector A(26 pins)
No.
Connector B(16 pins)
No.
Connector C(22 pins)
1
VBAT_LOAD
1
C_CAN_L
1
O_S ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV termina ...
Specifications, Consumer information and Reporting safety defects
Engine
Dimensions
Bulb wattage
■ 5 door
■ 4 door
Tires and wheels
Weight/volume
Recommended lubricants and capacities
To help achieve proper engine and powert ...
Copyright © www.kirmanual.com 2014-2024