Kia Rio: 4Door Side Body
|
|
|
|
| Front side member tooling hole (Ø12) |
Fender apron upper member tooling hole (Ø7) |
Front door upper hinge mounting hole (Ø13) |
|
|
|
|
| Front door lower hinge mounting hole (Ø13) |
Delta glass mounting hole (5.5X10) |
Side outer panel notch |
|
|
|
|
| Side outer panel notch |
Front door switch mounting hole (Ø9) |
Rear door upper hinge mounting hole (Ø13) |
|
|
|
|
| Rear door lower hinge mounting hole (Ø13) |
Side outer panel notch |
Side outer panel notch |
|
|
|
|
| Side outer panel notch |
Rear door switch mounting hole (Ø9) |
Quarter pillar moulding mounting hole (Ø7) |
|
|
|
|
| Rear bumper mounting hole (10X8.5) |
Rear combination lamp mounting hole (Ø6) |
4Door Front Body C
Engine mounting hole (Ø11)
Transaxle mounting hole (Ø12)
Engine mounting hole (Ø12)
...
4Door Interior
Front pillar trim mounting hole (Ø8.5)
Curtain airbag mounting hole (Ø6.6)
Cowl crossbar mounti ...
See also:
Hood Adjustment
Hood Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B)
by moving it up or down, or right or left.
2.
Adjus ...
Removal
1.
Turn ignition switch OFF, and disconnect the negative (-) battery
cable.
2.
Remove the battery and ECM.
(Refer to the Engine Ele ...
SRS Control Module (SRSCM) Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Copyright © www.kirmanual.com 2014-2024