Kia Rio: Audio Unit Removal
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or trim remover, remove the center fascia
panel (A).
|
| 3. |
Disconnect the start/stop button connector (A) and hazard switch
connector (B).
|
| 4. |
After loosening the mounting screws, then remove the audio assembly
(A).
|
| 5. |
Disconnect the audio connector and cable (A).
|
Audio Unit Description
Introduction to CD
•
If the temperature inside the car is too high, open the car windows
for ventilation before using your car audio.
•
It is ...
Audio Unit Installation
1.
Connect the audio unit connectors and cable.
2.
Install the audio unit.
3.
Install the crash pad center fas ...
See also:
Compressor Removal
1.
If the compressor is marginally operable, run the engine at idle
speed, and let the air conditioning work for a few minutes, then shut
the engine off.
...
Circuit Diagram
...
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
...
Copyright © www.kirmanual.com 2014-2024