Kia Rio: Specification - Engine Electrical System - Kia Rio UB 2012-2024 Service ManualKia Rio: Specification

Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0.75 ± 15% [20°C (68°F)]
Secondary Coil Resistance (kΩ)
5.9 ± 15% [20°C (68°F)]

Spark plug
Item
Specification
Type
SILZKR6B10E
Gap
0.9 ~ 1.0 mm (0.0354 ~ 0.0394 in.)

Condenser
Item
Specification
Capacitance (uF)
0.47 [1KHz]
Insulation resistance (mΩ)
1,000 [DC 500 V/1 Min]

Charging System
Alternator [AMS type (NON-OAD)]
Item
Specification
Rated voltage
13.5V, 90A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built-in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C 
Internal mode
-3.5 ± 2mV / °C


※ Regulator Setting Voltage (External mode)
Alternator [ISG type (NON-DAD) / AMS type (OAD)]
Item
Specification
Rated voltage
13.5V, 110A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built-in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C
Internal mode
-3.5 ± 2mV / °C


※ Regulator Setting Voltage (External mode)
Battery [Non-ISG type]
Item
Specification
Model type
CMF45L-BCI
Capacity [20HR/5HR] (AH)
45/36
Cold Cranking Amperage (A)
410 (SAE) / 330 (EN)
Reserve Capacity (Min)
80

AGM Battery [ISG type]
Item
Specification
Model type
AGM 70L-DIN
Capacity [20HR/5HR] (AH)
70/56
Cold Cranking Amperage (A)
760 (SAE) / 610 (EN)
Reserve capacity (Min)
120


     
Model type description


Cold Cranking Ampere (CCA): Cold Cranking Amps is a rating used in the battery industry to define a battery's ability to start an engine in cold temperatures.
-
The rating is the number of amps a new, fully charged battery can deliver at -18 °C(-0.4 °F) for 30 seconds, while maintaining a voltage of at least 7.2 volts for a 12 volt battery.
-
The higher the CCA rating, the greater the starting power of the battery.
RESERVE CAPACITY (RC) : Reserve Capacity is a battery industry rating, defining a battery's ability to power a vehicle with an inoperative alternator or fan belt.
-
The rating is the number of minutes a battery at 26.7 °C(80 °F) can be discharged at 25 amps and maintain a voltage of 10.5 volts for a 12 volt battery.
-
The higher the reserve rating, the longer your vehicle can operate should your alternator or fan belt fail.
Starting System
Starter [Non-ISG type]
Item
Specification
Rated voltage
12 V, 0.9 kW
The number of pinion teeth
10
Performance
[No-load, 11.5 V]
Ampere
Max. 60 A
Speed
Min. 5,500 rpm

Starter [ISG type]
Item
Specification
Rated voltage
12 V, 1.3 kW
The number of pinion teeth
11
Performance
[No-load, 12 V]
Ampere
Max. 95 A
Speed
Min. 3400 rpm

Engine Electrical System
...

Tightening Torques
Item N.m kgf.m lb-ft Ignition coil installation bolt 9.8 ~ 11.8 1.0 ~ 1.2 7.2 ~ 8.7 Spark plug installation 14.7 ~ ...

See also:

Thermostat: Installation
1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting (A). ...

Roll Over Valve (ROV): Repair procedures
Removal 1. Remove the fuel pump. (Refer to Engine Control/Fuel System - “Fuel Pump”) 2. Remove the roll over valve (A) after releasing ...

Inhibitor Switch Circuit Diagram
...

Copyright © www.kirmanual.com 2014-2024