Kia Rio: Inspection
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Remove the ECTS (Refer to "Removal").
|
| 3. |
After immersing the thermistor of the sensor into engine coolant,
measure resistance between the ECTS terminals 3 and 4.
|
| 4. |
Check that the resistance is within the specification.
|
Circuit Diagram
(M/T)
(A/T)
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
See also:
Foot Actuator (With Auto Defogging System) Description
The foot actuator is located at the heater unit. It adjusts position of
the foot door in heater unit of the vehicle equipped with the auto defogging
system. ...
SS-A Solenoid Valve(ON/OFF) Installation
1.
Installation is the reverse of removal.
•
When installing, ...
Ending voice recognition
While Voice Recognition is operating
Press and hold
the key on
the steering remote controller (over 0.8 seconds)
While using voice command, pressing any steering wheel control or a differen ...
Copyright © www.kirmanual.com 2014-2024