1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the driver airbag module.
(Refer to the RT group - "DAB and Clock spring")
|
3. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
4. |
Remove the steering wheel cover (A) after loosening 6 screws.
|
5. |
Remove the remote control switch (B) after loosening 2 screws
and disconnecting the connector (A).
[RH]
[LH]
|
Trunk Trim Replacement
•
Put on gloves to protect your hands.
•
U ...
Rain Sensor Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are controlled
by the ...
Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...