Kia Rio: Audio Remote Control Inspection

1.

Check the audio remote control switch (A) for resistance between No.5 and No.7 terminals in each switch position.

Switch	Connector terminal	Resistance (± 5%)
SEEK UP	6-7 (LH)	430 Ω
SEEK DOWN	6-7 (LH)	1.11 kΩ
MODE	6-7 (LH)	2.11 kΩ
MUTE	6-7 (LH)	3.11 kΩ
VOLUME UP	6-7 (LH)	4.61 kΩ
VOLUME DOWN	6-7 (LH)	6.81 kΩ
CANCEL	3-4 (RH)	180 Ω
SET -	3-4 (RH)	330 Ω
RES +	3-4 (RH)	550 Ω
ON/ OFF	3-4 (RH)	880 Ω
SLD	3-4 (RH)	1.44 kΩ
VOICE	3-4 (RH)	10.71 kΩ

Switch	Connector terminal	Resistance (± 5%)
END	5-6 (Lower LH)	18.91 kΩ
SEND	5-6 (Lower LH)	40.91 kΩ
TRIP	5-6 (Lower RH)	2.54 kΩ
RESET	5-6 (Lower RH)	5.54 kΩ

Audio Remote Control Schematic Diagrams

Circuit Diagram (1) Circuit Diagram (2) ...

Audio Remote Control Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group - "DAB and Clock spring ...

See also:

Removal
1. Remove the transaxle assembly. (Refer to "Manual transaxle system" in MT group) 2. Remove the clutch cover bolts. Be care ...

Components
1. Hands free call switch 2. Mic 3. Front left speaker 4. Front right speaker 5. Audio head unit (hands free control) ※ There is no hands free jack. Thi ...

Warnings and indicators
All warning lights are checked by turning the ignition switch ON (do not start the engine). Any light that does not illuminate should be checked by an authorized Kia dealer. After starting the en ...

Categories

Copyright © www.kirmanual.com 2014-2024