1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the evaporator temperature sensor connector.
|
3. |
Measure resistance between terminal “+” and “-” of evaporator
temperature sensor.
|
4. |
Connect the evaporator temperature sensor connector.
|
5. |
Run the engine and turn the A/C switch ON, then measure the voltage
between the terminals of harness connector.
Specification
|
Troubleshooting
Symptom
Suspect Area
Remedy (Refer to page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drai ...
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing ...
Ignition Coil: Description
An ignition coil is an induction coil in an engine's ignition system which
transforms the battery's low voltage to the high voltage needed to create an
electric spark in the spark plu ...