1. |
Disconnect the negative (-) battery terminal.
|
2. |
Disconnect the evaporator temperature sensor connector (A).
|
3. |
Remove the evaporator temperature sensor (A) by pulling it out
after rotating 90° in a counterclockwise direction.
|
4. |
Install in the reverse order of removal.
|
Air bag collision sensors
(1) SRS control module
(2) Front impact sensor
(3) Side impact sensor
WARNING - Air bag sensors
Do not hit or allow any objects to impact the locations where air bag
or sensors are installed ...
Installation
1.
Installation is the reverse of removal.
2.
After installation, bleed the brake system.
(Refer to Brake system bleeding)
...
Schematic Diagrams
Circuit Diagram (1)
Circuit Diagram (2)
Circuit Diagram (3)
SRSCM Connector Terminal
Pin
Function (Connector A)
Pin
Function (Connector B)
...