Kia Rio: Front Door Adjustment - Exterior - Body (Interior and Exterior) - Kia Rio UB 2012-2024 Service ManualKia Rio: Front Door Adjustment

Glass Adjustment

     
Check the glass run channel for damage or deterioration, and replace them necessary.
1.
Remove the following items :
A.
Front door trim
B.
Front door trim seal
2.
Carefully move the glass (A) until you can see the glass mounting bolts, then loosen them.


3.
Check that the glass moves smoothly.
Door Position Adjustment

     
After installing the door, check for a flush fit with the Body, then check for equal gaps between the front, rear, and bottom, door edges and the body. Check that the door and body edges are parallel. Before adjusting, replace the mounting bolts.
1.
Check that the door and body edges are parallel.
[5 Door]


[4 Door]


2.
Place the vehicle on a firm, level surface when adjusting the doors.
3.
Adjust at the hinges (A):
A.
Loosen the door mounting bolts slightly, and move the door in or out until it aligns flush with the body.
B.
Loosen the hinge mounting bolts slightly, and move the door backward or forward, up or down as necessary to equalize the gaps.
C.
Place a shop towel on the jack to prevent damage to the door when adjusting the door.

Tightening torque :
(B) : 21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)
(C) : 34.3 ~ 41.2 N.m (3.5 ~ 4.2 kgf.m, 25.3 ~ 30.4 lb-ft)


4.
Grease the pivot portions of the hinges indicated.
5.
Check for water leaks.
Door Striker Adjustment
Make sure the door latches securely without slamming it. If necessary adjust the striker (A): The striker nuts are fixed. The striker can be adjusted up or down, and in or out.
1.
Loosen the screws (B) just enough for the striker to move.

Tightening torque:
(B) : 8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)


2.
Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment.
3.
Hold the outer handle out, and push the door against the body to be sure the striker allows a flush fit. If the door latches properly, tighten the screws and recheck.
Front Door Replacement
Front Door Trim Replacement    • Take care not to scratch the door trim and other parts. ...

Rear Door Components
1 . Rear door trim 2 . Rear door trim seal 3 . Rear door panel 4 . Rear door belt inside weatherstrip 5 . Rear door belt outside weatherstrip 6 . Rear door delta lower ...

See also:

Installation
1. Installation is the reverse of removal.    Coat the clutch clevis push r ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Direct control VFS[35R/C] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current value(mA ...

Steering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symp ...

Copyright © www.kirmanual.com 2014-2024