Kia Rio: Hood switch Removal

Hood switch Inspection

1. Disconnect the hood switch connector (A). 2. Check for continuity between terminals ...

Hood switch Installation

1. Install is reverse of removal. ...

See also:

Components Location
1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle Po ...

Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Dynamic Damper Replacement
1. Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to DS group - “TJ joint”) ...